Commercial Condensate Pump

Commercial condensate pumps are mainly used to collect condensate from steam systems, boilers, or air conditioning terminals (such as fan coil units and air conditioning units) and transport it to designated recovery points (such as boiler feedwater tanks or drainage systems). Their operating characteristics include intermittent operation, low flow rate, and low head requirements, but they have special requirements for automatic control, leak prevention, and cavitation prevention.

• 2.2L Water Storage Box
• Large Flow Design Compatible with 200kW Boilers
• Vertical Centrifugal Pump Configuration
• Stainless Steel Motor Shaft
• Automatic Start/Stop Function
• Forced Run Test Function
• Optional High-Level Safety Switch to Automatically Disconnect Condensation Device to Prevent Further Condensation
• Optional High-Level Audible and Visual Alarm to Notify Users in Case of Severe Flooding
• 3/8" Pagoda-Style Drain Connector with Built-in Check Valve
• Four 1-1/8" Top Inlets and Two 1-1/8" Side Inlets [Factory Status: Closed]
• Air-Cooled Motor with Built-in Thermal Protector and Independent Air Duct Design
• Equipped with Wall-Mounted Mounting Kit
• Maximum Water Temperature: 60°C
• 2-Meter, 3-Core Cable with Grounded 3-Prong Plug
• Optional 6-Meter x 3/8" Transparent PVC Drain Pipe
• Large Float with No Welding, Safer and More Stable

Designed for the automatic collection and removal of condensate from high-efficiency oil-fired and gas-fired condensing furnaces and boilers. Additionally, it is suitable for removing condensate from air conditioning, refrigeration, ice-making, and dehumidification equipment when drainage is not feasible or practical.

• Air conditioning equipment
• Boiler equipment
• Oil/gas condensing furnace
• Dehumidifier
• Ice maker

Tests showed that the noise level of the Commercial Condensate Pump during operation was less than or equal to 46 decibels.

To ensure optimal performance and lifespan, please note the following during installation and maintenance:

Installation Points: The pump should be installed below the condensate drain point to ensure gravity flow; the inlet pipe should have a downward slope to prevent air blockage; a check valve is recommended for the outlet pipe.

Routine Maintenance: Regularly check the float or level control mechanism for smooth operation; clean the inlet filter; for electric pumps, check the motor insulation and bearing condition.

Common Problems: Failure to pump water (check for inlet blockage or air blockage) and frequent start-stop cycles (check the float or sensor) are common problems; troubleshoot in this order.

Hot Tags: commercial condensate pump, China commercial condensate pump manufacturers, suppliers, factory, home macerator pump, Macerator Pump, sewage lift pump station, sewer lift pump station