Water supply booster pump has the characteristics of low noise, light corrosion resistance, beautiful appearance, small size, light weight and long service life.
Applications:
The water supply booster pump mainly applicable for
water supply.
01
Water treatment processes.
02
Industrial cleaner.
03
Water boosting on process
04
Heating and cooling for industrial process.
05
Air-conditioning system
06
Air freshening
07
heater device(soft water)
08
Fertilization/metering system.
09
Boosting (drinking water, light chlorine water).
10
|
|
|
|
|
|
Maintenance Notice:
It is prohibited to start the water supply booster pump frequently, it should disconnect the switch when the power supply is suddenly interrupt.
It is not allowed to use the suction valve to adjust flow.
When the water is insufficient, it should stop the pump.
If there is some abnormal noise, please stop the pump and check.
If the pump is not use for long time or stop in low temperature, water should be drained to avoid damaging the pump body as freezing.
Our Factory
|
|
|
|
|
|
|
|
Certifications:
|
|
|
|
|
| CE | ETL | TUV | RoHS |
FAQ
Q: The water supply booster pump does not run.
● The voltage is not correct.
● Fuse or thermal protector makes the pump stop running.
B:How to solution?
● Check the voltage on the nameplate.
● Check the fuse or thermal protector.
Q: The pump does not pump properly
● Too much high head.
● Too low water level
● Bottom valve not in water.No water
● Leakage of inlet pipe
B:How to solution?
● Check the suitable head.
● Check the suction head.
● Have the valve in the water.
● Fill the pump with water.
● Check the suction conditions.
Q: The pump runs but no water
● The foot-valve is blocked.
● The impeller is corrosive.
● The bottom valve is not in the water.
● No priming water.
● Leakage in suction pipe.
B:How to solution?
● Check the suction height and re-install the pump.
● Replace the impeller.
● Fill the suction section with water.
● Fill the pump with water.
● Check the suction conditions.
Q: The flow reduces obviously.
● The foot-valve is blocked.
● The head is too high.
● The water level is too low.
● The impeller is serious damage.
B:How to solution?
● Clean or replace the foot-valve.
● Check the installation height.
● Check the suction head and re-install the pump.
● Replace the impeller.
Q: The motor is over heating
● Low voltage or insufficient ventilation in pump room
B:How to solution?
● Contact the electric power company to supply stable voltage.
● Have good ventilation.
Q: The water supply booster pump stops soon after starting
● Low voltage or insufficient ventilation in pump room
B:How to solution?
● Contact the electric power company to supply stable voltage.
● Have good ventilation.